This is a thin, low-profile 2.0mm pitch connector 8.0mm in height after mounting and 4.5mm in width.
It is designed to meet the demand for high-density connection of internal wires to printed circuit boards. It is compact, highly reliable and low in cost.
This connector can be supplied with wires crimped on either one, or both ends, with the applicable terminal or with one end crimped with this terminal and the other end crimped with a different terminal, provided that they both share the same wire specifications. The wire length and wire colours are configurable from a standard selection.
Please click here to be taken to the bespoke wire configurator page, where you will have the option to design the crimped wire to suit your requirements.
The contact has long dimples near the centre to ensure a good connection at all times, even under conditions of vibration and mechanical abuse, and when used with low voltage and low current circuits.
The fully shrouded header has walls on all four sides to prevent improper connection to the mating housing and to prevent the intrusion of flux and other contaminants.
- Printed circuit board retention mechanism
The solder side of the header has a retention mechanism that prevents it from floating during soldering. As a result, the header can be positioned accurately.
- Surface mount model (SMT)
This connector is also available in a surface mount configuration. Its housing is made of heat resistant resin so that it is not adversely affected during reflow soldering. Because of its tiny size and ability to be surface mounted, this connector meets the demand for high-density mounting of components inside electronic products.
UL Recognized E60389
CSA Certified LR20812
TUV Certified R75087